Fan Switch Sub-Harness for K-Swap This will delete your need

This will delete your need for the factory oem igniter without having to cut or splice into the factory harness

Cable from Battery Positive + to Starter

This kit includes a seperate subharness to be spliced into your igniter plug (full instructions & materials included)

configured by your aftermarket ecu)

* These are supplied with all K20a Engine Harnesses *

Fan Switch Sub-Harness for K-Swap This will delete your needLooking to run a Fan Switch on your K Swapped Honda? We have the solution for you! For a clean install, simply plug our harness into your fan switch using the pre wired connector On your connector you have two wires one is a 30cm earth strap to be connected a suitable ground point on your chassis, the other is 200cm in length and covered in a black braided sleeving for a high quality finish in your engine bay, this is ran to your conversion harness