Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit To ensure the safety of

To ensure the safety of equipment it is recommended that design advice is obtained from a competent person and that appropriate risk-benefit assessment are carried out

ISO/IEC 24570 and ISO/IEC 29881

the thermal efficiency is obtained by the direct method of test and is established to within a tolerance of ± 2 % points

The report gives supplementary guidance on the use of all parts of ISO 5167 and information on the use of essential secondary instrumentation

test equipment and set-up as well as the test procedures and content of the test reports

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit To ensure the safety of1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with 7 24 tapers without automatic tool changers.